Plastic Fill Simulation
Design Optimization Technologies
Tools Through a plastic filling analysis we can simulate the injection molding of a part. This procedure eliminates costly guesswork from the design process, reducing the time from concept to production.
  • Gate placement
  • Runner balancing and optimization
  • Reduction of weld and meld lines
  • Locate and identify air traps and hot spots
  • Melt front advancement
  • Temperatures
  • Pressures
  • Cost reduction through optimization and material use

 

 

<home>
| tools | <solid modeling> <finite element analysis> <motion analysis> <plasic fill sim> <design opt>
| engineering services | <new product design> <failure analysis> <mechanical eng.> <electrical eng> <electronics eng> <thermal fluids>
| diagnostics | <forensic eng> <diagnostic eng> <materials eng> <production & repair> <machine & structural design>
| design/drafting services | <mechanical> <drawing conversion> <electrical> <technical illustration>
<contact>

©2000 Design Optimization Technologies, Site by AphelionIT
The Chemical Building | 721 Olive Street | Suite 800 | Saint Louis MO 63101

This site is optimized to run at 800 x 600 or higher (1024 x 768 or higher preferred) with Internet Explorer 5.5 or higher.